This traditionally made 1100 litre steel single skin heating oil storage tank is not only manufactured from quality steel but is also manufactured to comply with UK regulations.

As standard, this tank is supplied with:

• 2" fill with fill cap & chain
• 2" vent cap
• 1.5" socket for gauge
• 1" bottom outlet (at front of tank)
• 1/2" drain socket with plug (located at back of the tank)
• lifting eye for positioning the tank when empty
• Internal bracing

This tank is finished with a sprayed undercoat and a top coat of Holly Bush Green.

Tanks For Everything also includes a 4ft Clock face gauge and bottom outlet kit (includes filter and isolation valve) with this tank.

Options:

Channel Runners:

Channel runners can be provided for a small additional cost. Channel runners are approximately 50mm deep and span the width of the tank. These runners prevent the base of the tank from corroding if in contact with a concrete base as well as providing sufficient access to service the filter fitted to a tank outlet.

​Delivery:

FREE delivery of this product includes most mainland UK locations, however postcodes TR, DD, PH, IV, KW, HS, AB, PA, KA, KY, FK and G as well as Central London and Offshore locations will incur an additional delivery surcharge. Please contact us prior to ordering so we can quote the additional costs. This product is delivered to the kerbside. It is the customer's responsibility to move the tank from the delivery point to the final location.

Additional Information:

Single skin oil tanks can be installed at a domestic property where a tank with secondary containment (or bunded tank) is not required.

Generally a single skin tank cannot legally be installed if the tank is:

• in Wales
• in excess of 2500 litres
• within 10m of controlled water (river, stream, ditch, soakaway, septic tank etc.)
• located where a spillage could enter a loose fitting manhole or open drain
• within 50m of a well, borehole or spring
• located over a hard surface where a spillage could enter controlled water
• in a position where the vent pipe outlet is not visable from the fill point
• within an Enviroment Agency source protection zone 1 (see www.environment-agency.gov.uk)
• or in close proximity to any other environmental hazard
• All commercial properties must have tanks with secondary containment if they store over 200 litres of oil (single skin tanks can be used as long as they are inside a masonry bund which is impervious to oil and contains 110% of the primary tanks capacity).

If you are unsure as to whether you can legally install a single skin tank, please contact us before purchase on 0800 0568 350 so we can discuss the Oil Storage Regulations with you.

Or alternatively, please visit www.oftec.org for more information.

Tanks For Everything strongly recommends the use of a bunded oil tank as the safest and most secure method of storing oil. If in doubt please contact us or click here to view our range of steel bunded heating oil tanks.

All oil tanks should be installed by a competent person in accordance with the OFTEC regulations, British Standards and LABC regulations.